KTuner.com

I have a innovate wideband running to analog two. It shows lamda as 1.0 how can I get that to show 1.00? Add another number after the decimal.

I imagine if it was 1.01 you'd see that extra place.

KTuner wrote:I imagine if it was 1.01 you'd see that extra place.

The wideband is outputting the proper signals. I can use the logworks software to see the analog output of the gauge and everything seems fine there. ktuner reacting to the gauge but when im at lambda 0.92 it shows 0.90 and when it goes to 0.93 it jumps to 1.0 because its not giving me the extra decimal place.

Sounds like you programmed an input instead of setting up a wideband. There's a note at the bottom of the inputs tab outlining that those aren't for wideband overlay.

KTuner wrote:Sounds like you programmed an input instead of setting up a wideband. There's a note at the bottom of the inputs tab outlining that those aren't for wideband overlay.

I did that because I was using an OEM wideband and just wanted to log an aftermarket wideband to have a reference in the Datalog. It's works fine except I need that addition digit behind the zero.

Send in a support email.

KTuner wrote:Send in a support email.

I sent in the support email. I am currently using a beta and thank you for adding that option in for me.

No problem at all.