Page 1 of 1

2D view rpm index

Posted: Sat Jul 14, 2018 11:00 am
by bianyy
2D view rpm index is not changing when I am changing rpm index in fuel / ignition tables.

Re: 2D view rpm index

Posted: Sat Jul 14, 2018 5:09 pm
by KTuner
The index shouldn't change, the plot should. Does it not?

Re: 2D view rpm index

Posted: Sun Jul 15, 2018 12:03 am
by bianyy
the plot changes. but the index line does not, it may not impact ecm running, just giving a bad feeling if a plot for 7500rpm which is a changed index is plot on 6500rpm line which is its factory index.

Re: 2D view rpm index

Posted: Sun Jul 15, 2018 6:02 pm
by KTuner
You can switch low/high or choose the table again to have it refresh. I'll add a refresh when this is changed, too! Thanks!