Main Parameters/VTEC Settings/Engage & Disengage Speed

Post Reply
husseinholland
Posts: 122
Joined: Wed Sep 12, 2018 2:44 am

Main Parameters/VTEC Settings/Engage & Disengage Speed

Post by husseinholland »

Trying to figure out what these values mean.

I can't find anything in the online help that explains what these values mean - e.g

Engage Speed : 6
Disengage Speed : 3

Is that referring to gear, or what?

Please advise. I'm trying to determine what the governing parameter means.
KTuner
Site Admin
Posts: 3745
Joined: Mon Jul 22, 2013 8:13 pm

Re: Main Parameters/VTEC Settings/Engage & Disengage Speed

Post by KTuner »

husseinholland
Posts: 122
Joined: Wed Sep 12, 2018 2:44 am

Re: Main Parameters/VTEC Settings/Engage & Disengage Speed

Post by husseinholland »

Still doesn't actually define what the speed refers to - so I have to assume it's mph based on this sentence ?

"The Minimum Temperature setting and engagement speeds can prevent
VTEC activation when the vehicle is cold or not moving."
KTuner
Site Admin
Posts: 3745
Joined: Mon Jul 22, 2013 8:13 pm

Re: Main Parameters/VTEC Settings/Engage & Disengage Speed

Post by KTuner »

To help with clarification, since there's already engine speed settings for VTEC above that, what other speed are you confusing it with?
husseinholland
Posts: 122
Joined: Wed Sep 12, 2018 2:44 am

Re: Main Parameters/VTEC Settings/Engage & Disengage Speed

Post by husseinholland »

KTuner wrote:To help with clarification, since there's already engine speed settings for VTEC above that, what other speed are you confusing it with?
Who knows. Since it doesn't delineate MPH as the value definition, it could be some conversion factor for all I know, hence the question asking for clarity. :D
KTuner
Site Admin
Posts: 3745
Joined: Mon Jul 22, 2013 8:13 pm

Re: Main Parameters/VTEC Settings/Engage & Disengage Speed

Post by KTuner »

It never will since most of the world uses the KPH setting and you can choose in preferences.
husseinholland
Posts: 122
Joined: Wed Sep 12, 2018 2:44 am

Re: Main Parameters/VTEC Settings/Engage & Disengage Speed

Post by husseinholland »

KTuner wrote:It never will since most of the world uses the KPH setting and you can choose in preferences.
Got it. That reminded me to look at those after the new revision install. I found it under Edit/Preferences, however I couldn't find anything in the Help Index that actually outlined what preferences were available.
Post Reply

Return to “KTuner Software”