Page 1 of 2

Unable to open after install?

Posted: Wed Jan 22, 2020 12:09 am
by ShiftAustin
Opened today and got notified of updated software. followed instructions on site and downloaded new setup pack and completed install.
When attempting open I get a "application has stopped working" error. uninstalled and reinstalled, no change.
uninstalled, redownloaded, reinstalled, no change.
installed old .2 version, opens and runs, but now constantly trying to authenticate.
Operating on windows 10, and suggestions?

Re: Unable to open after install?

Posted: Wed Jan 22, 2020 12:17 pm
by KTuner
If you were able to run .2 you'd be able to run .5. There hasn't been anything changed in the software that would prevent it from launching, so check your security software and make sure you have enough RAM available.

Re: Unable to open after install?

Posted: Mon Feb 03, 2020 3:05 pm
by Icemanhunt
I'm having a similar problem, Reinstalled three times but the software doesn't load properly. Disable firewall and the antivirus but it didn't work. Any thoughts?

Re: Unable to open after install?

Posted: Mon Feb 03, 2020 3:47 pm
by KTuner
If it shows open in the bottom bar you may have minimized it. Maximize it.

Re: Unable to open after install?

Posted: Thu Feb 06, 2020 9:15 pm
by Icemanhunt
KTuner wrote:If it shows open in the bottom bar you may have minimized it. Maximize it.
It worked. Thank You.

Re: Unable to open after install?

Posted: Fri Feb 07, 2020 12:18 pm
by KTuner
No problem

Re: Unable to open after install?

Posted: Wed Mar 04, 2020 12:24 pm
by husseinholland
I made the mistake of downloading & installing the new version (10.9.6). Now it won't open no matter what I do. I uninstalled, reinstalled (3x), and going to the program folder & double clicking on the Ktuner app still doesn't open.

Tried restarting the laptop several times, still no good. Of course this always happens when I actually NEED to use it - I need to unlock the ECU so I can transfer the user board to the RSX ecu...

EDIT: I thankfully hadn't deleted the 10.9.5 version - that installed and opened just fine, so it's not my computer settings. I did check that the new version was under 'allowed apps" through the firewall.

Re: Unable to open after install?

Posted: Wed Mar 04, 2020 2:22 pm
by KTuner
Multiple thousands of users have been using 1.0.9.6. It would be on your end or you can try downloading again.

Re: Unable to open after install?

Posted: Wed Mar 04, 2020 4:12 pm
by husseinholland
KTuner wrote:Multiple thousands of users have been using 1.0.9.6. It would be on your end or you can try downloading again.
OK. So I don't lose the existing (working) version - if I install in a different location, will it still overwrite the existing version, or will it leave 10.9.5 also installed? Trying to make sure I don't get stuck. I typically don't have internet when I'm at the car, so it's a PITA when it tries to do the whole verification thing with a re-install.

Re: Unable to open after install?

Posted: Wed Mar 04, 2020 4:27 pm
by KTuner
You have the old installer, as stated, so you can install over it any time.