KTuner.com

Adjusted for those models that read rich. Sorry but this is just an absolutely terrible/lazy explanation of what this channel is. Lambda sensors are greatly affected by the pressure of the environment they're in. On turbo cars, this is why the sensor should always be located after the turbo. Howeve...

Correct, the padding controls the transition between normal operation and closed throttle, which, by design, slows the throttle closing which also slightly affects the rev hang. Regardless, this isn't the main issue I'm trying to ask about so I'm not too concerned with it. Anyway, you mentioned &quo...

Understood. The padding seems like a band-aid and helps very slightly but also increases rev hang a bit. Unfortunately this behaviour is felt even when fuel cut is disabled or not active. The real problem seems to be the low/bottom end of the "throttle command" table. It seems to not have ...

I've been experiencing jerking especially in lower gears at very light throttle, most noticeable in traffic, 1st gear, > 2500 RPM. It was just barely present on the stock flash, but is noticeably worse when rev-hang is disabled. I took some datalogs and it's very clear to see the problem - between 0...

http://ktuner.com/KTunerHelp/early_spool.htm Early Spool starts the turbo spooling process sooner than factory adding additional low end and mid-range. It greatly improves overall drivability and does well in combination with the Part Throttle Turbo Responsiveness Quick Adjustment. http://ktuner.co...