KTuner.com

When setting the on board logging parameters in the "activation window" does activation occur only when all of the five parameters are met or just one (assuming my switched input is active)? Also, does the deactivation take place when all of the five parameters are met or just one? I am ac...

KTuner wrote:There's a table in preferences.

That was easy thanks. Is it possible to graph the analog inputs? I do not see them as one of the parameters that can be "added" to the graphing function.

I am using Analog Input 1 to log a external wideband. Is it possible to make the units read AFR rather than voltage so that every time I review the data I do not have to convert from voltage to AFR? I just want to confirm I am not over looking a input table to correlate voltage to AFR.

Is anti-theft still in beta testing? Any ETA on when it may be released in an update?

The wheel just needed to spin faster to register. Works perfect, thanks for the support.

I used the RD2 cable to connect to the 4pin speed input on the ECU. 1+:Brown FRS+: GRN/BLK 1-:Green FRS-: BLU 2+: Blue RRS+: GRN/YEL 2-: Black RRS-: BLU/YEL Tested SPD1 using right front speed sensor (1+ to FRS+ and 1- to FRS-). I am receiving a VSS signal when I turn the FR wheel however no SPD1 si...

Simple enough. Is there a cable with pigtails that would work for making the four connections at the ECU? Perhaps the 4 pin RD2 cable work (RD2C01)?

Is there a wiring diagram available to wire the speed inputs to the board to enable traction control? If not Is it correct to just assume 1 front wheel gets wired to sensor 1 and 1 rear wheel to sensor 2 with can be spliced at the ABS unit?

As we have previously discussed I have set up a input (switch) to activate my water/methanol system. http://i.imgur.com/swbD4Uw.jpg I am looking to purchase a fail safe (Safe Injection) unit for my system. In the event of no flow it triggers a 12V signal. E16 with 12V applied the ground = off. If 12...

I am looking to run a water/methanol setup and wish to run the activation through Ktuner like many have done with Kpro using the E21 input and E22 output (Nitrous tab). I can not find a schematic on what wires are used for the 6 programmable inputs/outputs that are available. Any input would be grea...