KTuner.com

Fueling is what I'm looking at next. My MAP sensor fluctuates with the fueling but appears to be within an acceptable mBar range (315-350). I'll know for sure when the new map sensor gets here. After a 20 min run, the only code my car temporarily throws is for the ECT sensor, so I've ordered one of ...

Thanks again! I was able to get it to idle at a desirable RPM by adjusting the parameters under advanced idle control. However, the surging is more prominent and appears to be related to unstable MAP readings with AFR fluctuating alongside it. Going to check again for an exhaust leak and have ordere...

Thanks for the swift reply! I was in looking at the idle ignition timing but there was a section that advises to not touch it (I believe it was under an advanced section though). Given the circumstance, which would you advise to alter first? The car runs fine under load but at idle it drops too low ...

I've got an 05 Base 5 speed with a k20A3. I have recently installed an RBC intake manifold, IMG, Type-S throttle body (K20A2) with brand new TPS (made sure to rewire it properly). TPS is working and reads perfect. I deleted the IACV and disabled it in KTuner. Used a block off plate to close it off. ...

I've been unable to find specific information regarding oxygen sensors and KTuner aside from the fact that it will work with the factory 05-06 sensors. However, both of my stock sensors are gone and I need to replace the primary and will disable the secondary when switching to a RH. Will KTuner work...